Press for disassembly and stippling of cardan shafts P1515K

The bench for disassembly of cardan shafts P2515K
The bench for disassembly of cardan shafts P2515K
The bench for disassembly of cardan shafts P2515K
The bench for disassembly of cardan shafts P2515K
The bench for disassembly of cardan shafts P2515K
The bench for disassembly of cardan shafts P2515K
It is designed to disassemble and assemble hinges, forks pressing and splined pairs into the cardan shaft pipe, remove and install the suspension bearing and sliding flange of the cardan shaft, stippling the crosses of the cardan shaft forks during repair and production.
Thanks to the replaceable tooling, the press can be used to assemble and disassemble various units and parts, as well as for technological operations such as bending, piercing keys, installation of bearings, stamping, straightening. Control of hydraulic cylinder force and displacement is performed by means of dosing pump. By turning the wheel left or right, you can control movement and speed at the same time and very accurately. The force acting on the workpiece will also be proportional. When the wheel is released, the force on the workpiece also decreases to a minimum. Precise adjustment of the system operation parameters is achieved by means of a pressure control valve.
Parameters P1515K
Maximum compressive force, kg 12000
Maximum cylinder stroke, mm 400
Maximum billet height, mm 416
Table dimensions, mm 900х384
Hydraulic cylinder rod speed Set manually
Oil tank volume, l 40
Overall dimensions of the equipment, mm (L x B x H) 828 х 1237 х 2205
Press weight, kg (approximately) 600
Parameters of the supply network 380V ± 10%, 3 Ph, 50Hz ± 1
Power consumption, minimum, kW 2.2
The bench for disassembly of cardan shafts P2515K
Press for disassembly of cardan shafts P1515K
Set of thrust forks for disassembly of joints of the press tooling P1515K 1 set
Lift with guide for support of gimbal 1 set.
Operating Manual 1 pc.
Fork 27 1 pc.
Fork 42 1 pc.
Fork 48 1 pc.
Fork 52-53 1 pc.
Fork 57 1 pc.
Fork 65-72 1 pc.
Stop 1 pc.
Additional equipment* Centering bracket for stippling
Stippling punches of crosses with diameters 19mm, 22mm, 24mm, 25mm, 27mm, 30mm, 31mm
* - The need for delivery and volume are specified separately, the cost of the basic delivery set is not included, it is paid additionally.

WE OFFER A COMPLETE SOLUTION, SUPPORT AND TRAINING WHEN YOU PURCHASE

Our company has a technical support service center. If you have any questions, you can contact us for help.
Commercial offer for the equipment

Leave your request and our manager will get in touch with you to detail the commercial offer preparation.