MACHINE FOR BALANCING 4-SUPPORT CARDAN SHAFTS MODEL BVI-03-77D

Balancing machine special 4-support model BVI-03-77D

MACHINE FOR BALANCING 4-SUPPORT CARDAN SHAFTS MODEL BVI-03-77D
MACHINE FOR BALANCING 4-SUPPORT CARDAN SHAFTS MODEL BVI-03-77D
The method of eliminating the imbalance is by welding corrective weights (plates) by contact welding. The machine is equipped with one welding tongs on guides, with the ability to move along the bed
Characteristic features of 4-support special balancing machine:
  • the possibility of balancing 2, 3 and 4 support cardan shafts;
  • frequency-controlled asynchronous electric drive;
  • combination of optimal design and low cost;
  • displaying the magnitude and angle of imbalance on a 17-inch touch screen monitor in 4 planes simultaneously;
  • simple and intuitive software interface.
Options BVI-03-77D
Machine type pre-resonant
Mass range of balanced rotors, kg 5 … 150
Maximum pipe diameter, mm 140
Maximum flange diameter, mm 250**
Maximum length of cardan shaft, mm 200 … 4200*
Number of supports 4
Number of simultaneously measured planes 2, 3, 4
Rotor speed range, rpm 400 … 4000
Minimum achievable residual imbalance, g mm / kg 5
Machine weight, without base cabinet, kg no more than 1900
Balancing protocols: printed out on a laser printer connected to the PAK-4 via the USB port, recorded on a USB flash drive or transferred via an Ethernet channel +
Transmission type belt
Machine balancing system PAK-4
Calibration of the balancing system of the machine calibration weights, 3-run method

Machine for balancing 4-support cardan shafts model BVI-03-77D

Commercial offer for the equipment

Leave your request and our manager will get in touch with you to detail the commercial offer preparation.






    FOR FREE
    We will correctly calculate the allowable residual imbalance tolerances according to your drawings. Balance right!
    Calculate